Skip to content Skip to sidebar Skip to footer

How To Remove Carpet Edge Strip


How To Remove Carpet Edge Strip. How to remove tack strip from a hardwood floor without damaging the hardwood. This material is used to keep the carpeting and padding from moving while it is being walked on, day in and day out.

8 Images Removing Carpet Tack Strips From Asbestos Tile
8 Images Removing Carpet Tack Strips From Asbestos Tile from alquilercastilloshinchables.info

In this video i share my diy strategy on how to remove old flooring transition strips without damaging the existing floor Discard the cut off piece of carpet. Remove the wood screws or screws for anchor with the appropriate screwdriver.

Pull Toward You To Detach It From The Sharp Tack Strip That Holds It To The Floor Along The Wall.


Grab the edge of the carpet and push it over onto the tack strip. Use your knee kicker to kick the carpet over into place so that you will have some extra to work with. Use a flat head screwdriver and a wrecking bar to gently pry the strip off the tacks underneath.

When You Can Reach In Under The Carpet, Pull Up The Whole Corner.


Steps to removing tack strips without damaging the floors underneath: Sorry i took so long to post a finished pic. Remove the edge strip and use the drill with the proper bit to drill pilot holes for the screws being used.

If The Spots Are Still There, Then You’ll Have To Resort To Some Detergent.


Place the crevice tool on your vacuum cleaner hose and run it along the affected area. If the old carpet was installed over a subfloor that you plan to cover again, insert the pry bar directly under the tack strip. Remove the wood screws or screws for anchor with the appropriate screwdriver.

When The Corner Of The Carpet Is Loose, Use Your Gloved Hands To Pull Along The Length Of The Wall Until All Edges Of The Strip Of Carpet Are Free Of The Tacks.


Fold back about 3 ft. Hit the other end of the pry bar gently with a hammer. Discard the cut off piece of carpet.

Insert The Chisel At The Outer Edge Of The Strip, And Lift Up On The Handle To Pry Up And Remove The Old Strip.


After the carpet is loose, you'll see where the strip is nailed down. Start with a clean area. Lift up the edge of the carpet to expose the screws that fasten the flat portion of the strip to the subfloor or concrete slab.


Post a Comment for "How To Remove Carpet Edge Strip"