How To Remove Rust From Electric Motor
How To Remove Rust From Electric Motor. I did a restoration on a south bend metal lathe and used electrolysis for not only rust removal but grease, oil, paint, and general grime and grit removal as well. You can easily see the bearing caps and the detent lever is visible.
The parts in the picture are the detent lever off a 1929 fuller and johnson nc engine and the. #101606 sat jul 14 2007 06:57 pm. Remove the paint around the rust with a dual action (da) sander.
I Did A Restoration On A South Bend Metal Lathe And Used Electrolysis For Not Only Rust Removal But Grease, Oil, Paint, And General Grime And Grit Removal As Well.
Sprinkle salt over the rusted area so that it is thoroughly coated and then juice a lime over the top. The only other thing i can think of is that if there is very large removal of metal or change in structure=> magnetic properties of metal, the effective airgap may increase, resulting in increased magnetizing current and decreased breakdown torque. About press copyright contact us creators advertise developers terms privacy policy & safety how youtube works test new features press copyright contact us creators.
Dip The Brush In The Hot Water, Tap It Against The Side Of The Bucket And Scrub.
Start with 80 grit and work your way up to 150 grit. Rhatcher (electrical) 31 dec 03 18:40. Remove the paint around the rust with a dual action (da) sander.
The Majority Of The Rust Can Be Removed Using The Hot Water And The Wire Brush.
Those two half round pieces of ferrite are the magnets that should be glued to the motor cover. Wash the engine block with the wire brush. First, use a wire brush to scrape off any rust dust or flaking paint on the item you wish to clean.
Not Just A Light Spray But Soak It Well, Let It Run Off And Dry For A Day Or Two.
Start low and work your way up. I would scrub it with a plastic pot scrubber and some vinegar to remove the rust and then rinse well in water. Thus some minor deterioration of insulation of rotor laminations should not be a matter of concern.
If There Are Any Plastic Zip Ties Holding The Wires Together ,Remove Them As Well.then Open The Metal Box By Removing The 4 Screws That Hold It Closed.
Look for the old glue marks. To make it easier to polish. *i made an error in this video*you want the ground connection to the parts that you want to remove the rust from, and the positive connection on the sacrific.
Post a Comment for "How To Remove Rust From Electric Motor"